Removing Super Glue
Super Glue is renowned the world over for the strength of
its bonds, it versatility of use, and easy application. Whether
a hole needs a seal or a crack needs repairing, Super Glue is the
first thing that craftspersons, hobbyists, and contractors use
for all their construction or repair needs.
Because Super Glue is so strong and bonds
so fast, some people may find that they
have accidentally glued two fingers together,
or found that that small piece of balsa
wood or plastic from a model they were
building has completely bonded to their
skin! Not to worry, for even though Super
Glue is incredibly strong, it has one weakness:
acetone.
Acetone is often found in household nail
polish remover, and a small amount on the
end of a Q-tip or cotton swab applied directly
to the glue should dissolve the bond without
damaging the skin. Be very cautious in
gently peeling the skin apart as in removing
a bandage from the skin; pulling the skin
apart may rip the skin! Read the label
to make sure that the remover actually
contains acetone, as more and more manufacturers
are turning away from the chemical because
of the growing popularity of acrylic nails
(which are
loosened
by
acetone).
Be careful - straight
acetone will discolor a number of fabrics
and can mar the finish of laminated counter
tops (mainly the darker colored ones).
Straight Acetone defats the skin; wash with soap and
water after use and apply hand lotion to replenish
the skin and remove any dryness effects. Use
acetone sparingly and cautiously with these
tips in the following situations:
- Use acetone and an old toothbrush, reapplying the acetone
a number of times and brushing to remove it layer-by-layer. Work
on outside and then on inside. May not come off entirely.
- .
Use acetone to soften glue and then start working at the glue. Brush, scrape,
shave, peel, sand or whatever mechanical means is available to work the
glue off. Reapply acetone and continue to work at the glue.
- Standard Super Glue is not recommended to be used for glass
bonding applications. If bonded, soak in water until parts come
apart.
The best suggestion is to properly cover your work area
with metal foil before use - and always work with Super Glue and
other adhesives in a well-ventilated area!
Should Super Glue bond to any body part where acetone should not
be applied, such as the lips or eyes, the following steps will help
you get out of any sticky situation!
- Immerse bonded areas in warm, soapy water. Peel or roll
skin apart; a spatula or teaspoon handle or even a pencil will
help. Remove cured adhesive with warm, soapy water (may take several
applications). Fingernail polish remover with an acetone base has
also been successful for removal of cured adhesive from skin.
If lips are accidentally stuck together, apply a generous
amount of warm water and encourage maximum wetting and pressure
from saliva from inside the mouth. Peel or roll (do not pull) lips
apart. It is almost impossible to swallow the adhesive as a liquid.
The adhesive solidifies upon contact with saliva (moisture) and
could adhere to the inside of the mouth. Saliva will lift the adhesive
in 1-2 days, avoid swallowing the adhesive after detachment.
In the event that eyelids are stuck together or bonded
to the eyeball, wash thoroughly with warm water and apply a gauze
patch. The eye will open without further action within 1-4 days.
To our knowledge there has never been a documented case of adhesive
in the eye causing permanent damage. Do not try to force eyes open.
- The adhesive will attach itself
to the eye protein and will disassociate
from it over time, usually within several
hours. Periods of weeping and double
vision may be experienced until clearance
is achieved. Use of a warmed 3% sodium
bicarbonate solution to wash eyes repeatedly
may assist in aiding more rapid removal
of the adhesive.
WE SUGGEST THAT ALL INCIDENTS OF
EYE EXPOSURE TO CYANOACRYLATE ADHESIVE
(SUPER GLUE) BE DISCUSSED WITH A PHYSICIAN.